Expamet Products

Acts as a carrier for plaster where no key or backing is present Can be used over chases/columns to prevent cracking Can be moulded into curves/domes Can easily be cut to size using tin-snips or aviation cutters Fixing Type: Galvanised Clout Nails/Staples/Screws and Washers A 5-6mm gap must be provided between the lath and substrate Overlap sheets 50mm along short edge, and 25mm along long edge Fixings to perimeter at 150mm intervals, central fixings at max 350mm in a staggered formation Sheets should be staggered in a stretcher (brick bond) arrangement If overlaps are unsupported, they must be wire-tied at 150mm centres

Minimesh wing provides a key to prevent cracking Provides a clean straight corner and protects plaster edges from damage Can easily be cut to size using tin-snips or aviation cutters Fixing Type: Galvanized Clout Nails/Staples/Grab Adhesive/Plaster Fix at intervals not exceeding 600mm Avoid damage to beads when trowelling. Do not use abrasives to clean beads.

Single piece, non welded construction Non coaxial fixing holes 600g/m2 galvanized coating Manufactured 10mm less to allow for notching/joist regularisation Fixing Type: Built in to masonry - No mechanical fixings required to wall. 3.75x30 square twisted nails to connect joist. Back of hanger must be tight against wall. Joists are to be cut square with a gap not exceeding 6mm from the rear of the hanger. A minimum 675mm of set masonry must be in place over support flange before loads are applied. Joist to be nailled through side gusset using 3.75x30mm square twisted nails. The underside of joists should be notched to provide a level surface for plasterboarding. Declared Loadbearing Capacity : 7.5kN SWL (SLS)