Expamet Products

Expanded wing reinforces plaster to prevent cracking Provides a straight edge and protects plaster edges from damage Can easily be cut to size using tin-snips or aviation cutters Fixing Type: Plaster/Grab Adhesive/Nails/Staples Fix at intervals not exceeding 600mm Beads may be wire tied to the face of metal lathing backgrounds Avoid damage to beads when trowelling. Do not use abrasives to clean beads."

Perforated wing provides a key to prevent cracking Fixing holes to suit a standard plasterboard nail Provides a clean straight corner and protects plaster edges from damage Can easily be cut to size using tin-snips or aviation cutters Fixing Type: Galvanized Clout Nails/Staples/Grab Adhesive/Plaster Fix at intervals not exceeding 600mm Avoid damage to beads when trowelling. Do not use abrasives to clean beads."

Perforated wing provides a key to prevent cracking
Fixing holes to suit a standard plasterboard nail
Provides a clean straight corner and protects plaster edges from damage
Can easily be cut to size using tin-snips or aviation cutters
Fixing Type: Galvanized Clout Nails/Staples/Grab Adhesive/Plaster
Fix at intervals not exceeding 600mm
Avoid damage to beads when trowelling. Do not use abrasives to clean beads.

Minimesh wing provides a key to prevent cracking
Provides a clean straight corner and protects plaster edges from damage
Can easily be cut to size using tin-snips or aviation cutters
Fixing Type: Galvanized Clout Nails/Staples/Grab Adhesive/Plaster
Fix at intervals not exceeding 600mm
Avoid damage to beads when trowelling. Do not use abrasives to clean beads.

Perforated wing provides a key to prevent cracking Fixing holes to suit a standard plasterboard nail Provides a clean straight edge protecting plaster from damage Can easily be cut to size using tin-snips or aviation cutters Fixing Type: Galvanized Clout Nails/Staples/Grab Adhesive/Plaster Fix at intervals not exceeding 600mm Avoid damage to beads when trowelling. Do not use abrasives to clean beads."

Acts as a carrier for plaster where no key or backing is present
Can be used over chases/columns to prevent cracking
Can be moulded into curves/domes
Can easily be cut to size using tin-snips or aviation cutters
Fixing Type: Galvanised Clout Nails/Staples/Screws and Washers
A 5-6mm gap must be provided between the lath and substrate
Overlap sheets 50mm along short edge, and 25mm along long edge
Fixings to perimeter at 150mm intervals, central fixings at max 350mm in a staggered formation
Sheets should be staggered in a stretcher (brick bond) arrangement
If overlaps are unsupported, they must be wire-tied at 150mm centres